Flat & Low-Slope Specialists  ·  Garages, Additions, Porches  ·  PA Licensed

EPDM Rubber Roofing in
Conway, PA

Single-ply rubber membrane for flat and low-slope roofs.
Garages, additions, porches, and commercial. Free inspection.

Flat & Low-Slope Seam-Welded & Flashed PA HIC #PA203687 Free Inspection
← All Conway, PA Services

Conway, PA — EPDM Rubber Roofing

EPDM Rubber Roofing in Conway, PA

Plenty of Conway properties have a flat or low-slope section, over a porch, an addition, or a whole commercial building. Shingles do not belong there. EPDM is a single-ply rubber membrane made for slopes too shallow for shingles to shed water.

Flat Roofs and Conway Weather

Standing water is the enemy on any flat roof, and drainage is what we look at first. Seams, terminations and flashing at walls and curbs are where low-slope roofs actually fail. Conway sits along the Ohio River, so we start every inspection on the elevations that take the most exposure.

EPDM Work We Do in Conway

We install fully adhered and mechanically attached EPDM, rebuild parapet and curb flashing, repair open seams, and correct drainage with tapered insulation. We also handle porch and addition roofs, which are the most common calls here. We cover the whole borough and the rest of Beaver County.

Working on Conway Homes

Conway was incorporated on June 3, 1902, on ground first settled around 1800 by John McKee. Conway Yard, a Norfolk Southern classification yard and locomotive facility, was built in 1884 and was the largest rail yard in the world from 1956 until 1980. We work on that stock the same way every time: get on the roof, open up what needs opening, and show you photographs of what is actually there before anyone talks about price.

Houses that went up in the same stretch of years tend to fail in the same places, and after enough jobs on one street you learn where to look first. That is worth more to a homeowner than a bigger crew or a faster quote. Flat sections on older buildings are usually additions, and additions are where drainage goes wrong.

Conway at a Glance

Conway counts 2,168 residents, which tells you roughly how much of the housing here went up in the same few decades. Local students attend Freedom Area School District, and a good share of our work comes from neighbors on the same streets talking to each other. The 15027 ZIP Code is on our regular run, not a special trip.

We cover all of it, and the rest of Beaver County with it.

Porch and addition roofs price very differently from full commercial decks, so we measure both. EPDM handles cold and movement well, which matters more here than reflectivity does. Anything under about a 2:12 pitch belongs on a membrane rather than under shingles.

Tapered insulation fixes the slope instead of patching around the puddle every couple of years. Our registration and insurance cover low-slope work across Beaver County the same as steep-slope. A test cut tells us what is under the membrane, which guessing never will.

Small porch roofs and full commercial decks are different jobs at different rates. White membrane suits a building fighting summer heat gain; most homes here are not that building. Shingles on a shallow pitch fail at the laps, and no amount of sealant fixes that for long.

Ponding that dries within two days is normal; ponding that never dries is a design fault. Curbs, vents and skylights are where low-slope roofs actually leak, so that is where we start. We photograph the deck before the membrane goes down so you know what you paid for.

Flat & Low-Slope Systems

Membrane Systems We Install in Conway

EPDM and single-ply membranes for the flat and low-slope roofs shingles can't protect — garages, additions, porches, and commercial.

Most Common · Residential

Fully-Adhered EPDM

Black rubber membrane bonded directly to the substrate. Flexible in cold, stable in heat, and the go-to for Conway garages, additions, and porch roofs.

Seams heat-welded and flashed
Larger & Commercial

Mechanically-Fastened EPDM

Membrane secured with fasteners and plates, ideal for larger low-slope and light-commercial roofs. Faster install on wide, open spans.

Reinforced seams
Reflective Alternative

TPO Single-Ply

A white, heat-reflective membrane for owners who want lower cooling load on a flat roof. Hot-air welded seams. We help you weigh EPDM vs. TPO for your roof.

Reflective surface

Our Process

How We Install EPDM in Conway

01

Inspection & Measurement

We inspect the flat or low-slope area, check for ponding and failed seams, and measure the exact membrane and insulation your Conway roof needs.

02

Tear-Off & Deck Check

Old membrane comes off. We inspect the deck for rot or soft spots and replace compromised sheathing before anything new goes down.

03

Insulation & Substrate

Proper cover board and insulation for a smooth, dry base. The right slope-to-drain detailing so water leaves the roof instead of pooling.

04

Membrane Installation

EPDM is fully adhered or mechanically fastened to spec. Clean layout, correct adhesive, no shortcuts on a roof that has to hold water.

05

Seams, Flashing & Penetrations

Seams are welded and the edges, curbs, vents, and wall terminations flashed correctly. This is where flat roofs leak, so this is where we're careful.

06

Final Inspection & Walkthrough

Every seam and flashing checked. We walk the finished roof with you, clean up the site, and document the job with CompanyCam photos.

EPDM rubber roofing specialist in Conway, PA

Why TriState

Conway's Local Roofing Contractor.

Flat & Low-Slope Specialists

EPDM is a different system than shingle. We install membrane roofs built for the flat and low-pitch roofs shingles can't protect.

Seams & Flashing Done Right

Flat roofs fail at seams and penetrations. We weld and flash them correctly so water leaves the roof instead of finding a way in.

PA Licensed — HIC #PA203687

Permitted, insured, and accountable on every flat-roof job in PA.

Insurance Claim Specialists

If a storm damaged your flat roof, we handle the claim from documentation to negotiation for Conway homeowners.

FAQ

EPDM Questions from Conway Homeowners

EPDM installation in Conway typically runs $5 to $12 per square foot. The spread comes from membrane thickness, whether the old roof is torn off, insulation, and how many curbs and penetrations are involved. Small porch roofs price differently than full commercial decks.
They are different tools. EPDM is a black rubber membrane that handles movement and cold well; TPO is a white membrane that reflects heat. On small residential porch and addition roofs in Conway we most often use EPDM.
Yes. EPDM is for low-slope roofs, which includes anything too shallow for shingles to shed properly. Anything under about a 2:12 pitch belongs on a membrane rather than under shingles.
Usually because the deck has settled or the drainage was never right to begin with. Ponding water finds seams and terminations and works at them. We correct the slope with tapered insulation instead of just patching around the puddle.
Yes. TriState Home Consulting Group LLC is a registered Pennsylvania Home Improvement Contractor, PA HIC #PA203687, and carries general liability insurance. That registration covers EPDM and low-slope roofing in Conway and throughout Beaver County.
Open seams, failed terminations and ponding in one spot are usually repairs. Water under the membrane across the whole deck is not. We cut a test patch where it is safe to, so the answer comes from what is actually under there.

Get Started

Free EPDM Roofing Estimate in Conway, PA

Free inspection. Honest assessment of your flat or low-slope roof. Written estimate. No pressure.

724-308-9907 tristatehomeconsulting@gmail.com
PA HIC #PA203687
We respond within the hour

Get My Free Estimate

Serving Conway, PA & all of Beaver County · No commitment required

Pick a time that works for you: